RAK 19026 Starter Kit Meshtastic Wisblock Case The components must be installed in this order: RAK 19026 BLE antenna GPS antenna LORA antenna Ensure the wires do not overlap any screw

I wanted to use the Meshtastic logo on an enclosure design and there is a great design repo that has helpful guidelines and 3 different variations of SVG versio

The original "RAK Meshtastic Starter Kit - No Additional Hardware Case" (published on Printables by pdxlocs) has gaps along the bottom edge, surrounding the USB-C port in the bottom of the front cover

This is a weatherproof (or waterproof depending on the version) case for a RAK19003 based Meshtatic node. Since the RAK19003 includes a Li-ion charging circuit and solar panel input port, the cases ha

Meet the "Go Node"! Pack it around as a portable unit or install it as a stationary node. It can be hung up, mounted with screws, or simply propped up in the sun with the attached stand. Includes a

I'm on a bit of a bargain-basement kick, and wanted to see how cheap I could get a pocket node. After a lot of shopping around, here's what I've managed to cobble together. It's definitely a lot more

Can be stacked on top of, or replace, the backplate of a Station G2 to hold the Veektomx 10,000mah battery recommended by B&Q (https://a.co/d/aPFeN6z) ...Cause why not? Recommend printing with suppor

Will probably change a bit later, I think it still needs a cover for the front and a better solution for the battery for accommodating bigger/different batteries Has space for a 503562 lipoly, as tha

Gutter mount case for RAK 19007 meshtastic device. The curled bracket clips in under the gutter rim and the opposite end can be press fitted between the wall and the guttering for a solid fit. Screw

This allows you to add additional space to the back of your LILYGO® T-Echo device to fit a bigger battery. Download the version that gives you the space you need; 3, 4, 5, or 6 mm. The advantage of th

Just a quick model I whipped up to be able to press the buttons on the back, when in the included "case"

A bracket to mount a Station G2 to the top of the Airframes 915Mhz cavity filter. Might be a little thin, will modify if it doesn't hold up for me.

A simple Multibin insert for holding three RAK Wisblock 19007 boards when doing firmware updates, etc. The three boards

All the printed parts necessary to put a solar mesh radio into a tree! Includes case, tri-hanger and spool. Full details at https://www.maplemesh.org/2025/11/05/Hanging-Nodes-in-Trees.html Carabiner

LoRa Square Post Case (XIAO nRF52840 & Wio-SX1262 + 26650+10w) For 1.5" Square Posts. Additional holes might need to be drilled! 1/4" hole for bolt to secure case to post Print 2 halves, glue or tape