Doorbetter tolerance.stl
1.3K downloads · 5 years ago · made an adorable little dumpster for 2020, ive wanted others to make things to put into it , i curre
made an adorable little dumpster for 2020, ive wanted others to make things to put into it , i currently use it to hold small items on my desk
Gridfinity Pinecil & Tip Holder with some tolerance.stl
Dowel Mid Extra tolerance.stl
pumpkintogepi.stl
TVA Time Baton
Boastful Loki Hammer
oopsright.stl
left.stl
CuteDumpster.stl
ramhornCrewmate.stl
SittingCrewmate.stl
CrewmatePumpkinhead.stl
cathatsittingcrewmate.stl
Demonimposter.stl
plaguedrCrewmate.stl
sitcrewmatehead.stl
childcrewmate.stl
FO2crewmate.stl
BlankSittingCrewmate.stl
crewmateDevilhorns.stl
For what it's worth I've printed this top side down and did not have a problem removing the supports from inside with an exact-o-knife.
It took me a few tries to get the supports correct for this. I initially tried to print it on the face, but the supports in the recessed areas were too difficult to tear out and the finish would have been ugly. Then I tried to flip it and print it at a much more shallow angle, but supports that short were too difficult to remove from such a large area. I ended up printing it exactly as it imported with the doors angled at about a 45. The supports tore away quite easily. The bottom edges of the doors are a little wonky, but they are good enough for me (see the pic in the uploads).
Filament: eSun Semi-Transparent Grey PETG Printer: Prusa Mini+ w/ powder coated steel sheet
Just use a piece of filament to attach the lids to the dumpster. Fits perfectly. I think I read that on the Thingiverse page for this print.
How do the doors stay attached?
what did you use for the hinge ?