This is my Armattan Mongoose Rx and VTx trays. Easily holds a XM+ Rx or smaller, with a zip tie, and easy antenna routing out to the rear arms to be shrink wrapped to a zip tie. The upper portion can hold a older style VTx, or the pigtail from a stack mount VTx. There are two models for the VTx holder; with prop protecting fingers to route the battery lead up, or without.

I raced a Mongoose with this setup for 2 years, and it handled a lot of crashes, never once cut a battery lead, VTx antenna, or broke any of the printed parts.

Print in PLA, PETG, or ABS. TPU should work too, though is not needed.

Licensed under Creative Commons, Attribution, Non Commercial, version 4. https://creativecommons.org/licenses/by-nc/4.0/legalcode.txt