Orsa stands for minimalistic design and defined curves.

Printer: no AMS/multimaterial required 241x241x180mm built volume required

Print settings: shade: 0.16mm layer height vase mode/spiralize outer contour 6 bottom layers 0,7-1mm line width (dependent on filament and brightness wanted)

base/foot: 0.16mm layer height 3 walls supports: optional

adapter/foot screw: 0.12mm layer height 4 walls 50% infill

See images for print orientation All unlisted parts use standard print settings

Filament: For the shade use some whiteish filament. I used Spectrum PLA Ivory Beige. adapter and screw are recommended in PETG

Additional hardware: wood rod diameter=28mm L=1300mm (as you like) shade and foot add around 25cm to the height 4x wood screw 3,5x35mm 5x wood screw 3x12mm 1x E14 or E27 light cord