A long while back I released the skull moth spine hugger and everyone wanted a drawer pull version, and so here it is!!

There are two versions, one that needs a pause, and one that doesnt. With the version that needs a pause in the print, you have to add the pause at layer 31 (if using .2 layer height) which is the topmost layer before the cavity for the 8-32 nut gets sealed up. during the pause, add the nut and resume.

for the no pause version, you just print it and you can slide the nut into a cutout while you're installing it into a drawer or cabinet.

I used these 8-32 nuts and screws: click here

the pause version does not need supports.

the no pause version uses auto tree supports.