Pay with the Pointer Wand is a funny teacher-inspired tap-to-pay prop and 3D printable teacher appreciation gift. Point it at the reader, tap to pay, and walk away with the most authoritative checkout tool in the room.

I almost called it Pay with the Finger... but then I realized that probably isn't school appropriate. 🤐

• Snap Joint: Head and handle connect with a satisfying snap fit — semi-permanent by design. Can be separated with firm force if needed, or add a dab of CA glue for a permanent bond 🔒
• Cartoon Scale: Oversized for maximum impact

• Orientation: Print as oriented in file — hand prints vertically, handle lays flat. This is intentional for joint strength 💪
• Walls: 3
• Infill: 15%
• Supports: Manual support under male connector only ⚠️
• Pro Tip: Matte filament gives this a clean, bold look straight off the plate 🖤
• As an Amazon Associate I earn from qualifying purchases.
• 🎨 Filament Used: 3DHoJor - Joys And More Matte PLA - Black

• 💖 Pay with Love — the original
• 🍀 Pay with Luck — drive-thru favorite
• 🐰 Pay with Bunny Money — Easter edition
• 🪞 Pay with Good Looks — April member exclusive

• 👤 Personal Use: Print it, snap it together, point it at things 🫵
• 💼 Commercial License: Want to sell these at your local market or craft fair? Join the R7Makers Merchant Tier on Thangs for commercial rights to this file and the full catalog. New designs, seasonal drops, and member exclusives make the subscription worth it for sellers and collectors alike.

👉 JOIN THE R7MAKERS LAB: https://thangs.com/designer/r7Makers/memberships