The ONYX lamp has a subtle oval shape with a clean diamond pattern. The design is inspired by a classic lantern, but with a geometric twist. When the lamp is on, the pattern creates shimmering light accents and a warm glow. When off, the clean pattern stands out and the lamp looks like a modern design object.

Socket base: 8.8 x 3.3 cm (DxH) Socket cap: 7.4 x 5.3 cm Shade: 16.4 x 20.2 cm Resizable: no (resizing will affect the fit of the E26/E27 socket) 3D Model Type: Shade: solid body (vase mode only) | Base: shelled body (normal print) File type: STL Recommended materials: PLA, PETG (for shade) Print difficulty: moderate

What you need E26 or E27 lamp socket with screw rings, lamp cord with plug, LED bulb

Assembly instructions The lamp consists of three parts: a base, a cap and a shade.

1. Feed the loose cord (without socket attached) through the hole in the base from outside to inside.
2. Wire the socket to the cord according to the manufacturer's instructions.
3. Make sure only the bottom ring is mounted on the socket.
4. Place the shade loosely on the base.
5. Feed the socket through the shade and secure it to the cap with the ring.
6. Attach the cap and socket to the base by twisting it tight, clamping the shade in place. Make sure there is no tension on the cord, as it will move slightly while twisting.

Print settings — shade (vase mode) Nozzle diameter: 0.8mm or larger Layer height: 0.3 - 0.5mm Layer width: 0.8 - 1.2mm Print mode: vase mode (spiralize outer contour) Perimeter speed: 20-35 mm/s

Note: when using Cura or Bambu Studio, disable 'smooth spiral' for best results.

Print settings — socket base and cap (normal mode) Nozzle diameter: 0.4mm - 0.6mm Layer height: 0.25 - 0.3mm Layer width: default Bottom and top layers: 4 Infill: 40% Walls: 3 Outer wall speed: 20-35 mm/s Supports required: no Base orientation: bottom down Cap orientation: flat top side facing the bed