Personal use only unless you hold an active Thangs or Patreon Tier 2 or Tier 2 Plus commercial license. Digital resale or file sharing is strictly prohibited. You may sell only physical prints while your license remains active.

Welcome the Giant Cathedral Window Wall Shelf!

Print time: 24hours

Settings I used:

Layer Height: 0,24mm (better results at 0,16 or 0,20 if you are not in a rush.

Infill: 20%, you should go a bit higer if you want to put heavy things on it.

Support: Tree -> Auto -> 35º Degrees (its overkill but better safe than sorry!)

Use the 3MF file: opening Orca Slicer, Bambu Studio or Creality Slicer (make sure the negative part on the plate number 2 slices properly as negative part.

Enjoy this fun print!