👍 Don't forget to Like and Collect this, so you can easily find it later! ⭐ If you like my models then come follow and support me on Patreon - where you'll get access to exclusive models.

This is an Ebonclaw from Turn of Fortune's Wheel. I couldn't find one of these on the major print sites so I made one based off the battlemap token image. An Ebonclaw is kinda like a saber-toothed tiger except it can pounce on top of creatures and knock them prone. For a CR2 it has a pretty nasty +6 to hit too but the Saber-toothed tiger also gets that and a multi-attack and a bonus action disengage / hide. If you wanted to buff up this creature I think you could borrow those tiger features so that it can disengage - run away 20 ft and then run back in for another pounce. I'd also give it a the ability to critical hit on a 19 since tiger tend to go for weak points on their prey (back of the neck *chomp!)

This was an easier model that I made using an AI mesh from my backlog of models. I posed the model, adjusted some proportions in that pose, sculpted in some fur, further tweaks on positions of its paws and print optimized to fill in some holes but otherwise it's really the same as the AI base mesh.

For FDM printing I would try printing this straight up - it's going to need auto tree supports. I use thin supports usually at a 30-45 degree angle. I would go with 45 here which is annoying but it's better than a failed model. For Resin I've included a pre-supported file here.

You can follow along with me on Patreon here to get sneak peaks at my upcoming projects, exclusive minis / models and more!