A horizontal version of The Rail has been the most requested addition to this system, and I've finally worked it out! This version uses two dowels (1", 25mm, or 23mm). Using two dowels ensures the pots wont tip forward and will stay secure.

Two sizes of pots are included with this download.

How to mount to your wall

1. Slide middle wall mount onto dowels. Position it directly in the middle
2. Slide two planter attachments on either side of the middle wall mount
3. Place left and right wall mounts on the ends of the dowels
4. Insert the keyhole markers into the keyhole slots on the left, right, and middle wall mounts
5. Firmly press against wall in desired location and the keyhole markers will make an indent where you need to drill. Use a level to make sure it's straight
6. Drill holes using a 1/4" drill bit
7. Insert wall anchors and screws (#10 - #12 x 1-1/4" screws and anchors)
8. Make sure the screw head is sticking out just far enough to tightly fit in the keyholes. Use the included depth gauge to determine the distance the screw head should be sticking out
9. Attach rail to the wall
10. Slide planters on to attachments

Supports Supports are needed for the flat overhang on the back of the planters. Supports are not necessary for the attachments but can be used for the top inside of the holes.

Scaling This cannot be scaled because the keyhole slots are specifically designed for #10 - #12 x 1-1/4" screws and anchors.

Orientation

• Everything prints upright with its flat bottom on the build plate

Print Settings

• .2mm layer height
• 15% grid infill
• 2 walls
• Set bridge flow to 1.6 for drip trays

Filament

Bambu Lab Matte PLA

Colors I used:

• Ivory White

Hardware

• #10 - #12 x 1-1/4" screws and anchors

Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://linktr.ee/loftedgoods