I made this USB Stick holder to go on the front of my 3D printer, But I think it could also be used for other things. I found that because I have multiple USB sticks I often load my next print onto another USB stick and then when my print is finished I then swap them over directly after each print. I was also finding that during each print I would leave my USB sticks all over the place which would often mean I would miss place them so hopefully this should stop that 😀

Ps, I used a little bit of double sided sticky tape to mount this to the front of my printer so then its easily removable in the future if needed.

I am also sure that if someone needed to they could re-mix it to accommodate SD cards as I know some printers take SD cards.

Enjoy!