Hey, this Christmas Tree is both, a Fidget Toy and a Coaster. The Design was heavily inspired by last year's viral Christmas trees and John Edmarks nesting works. I did however make the first Spiral Shaped one, and it can be locked in place to be a Tree.

Print Settings: Standard no supports. Since we are printing only one line walls here, I recommend using clue on your build plate to make the stick nicely. Going slow can also help. You can also add a Brim, but that might make it look bad.

Assembly: The Tree is print in Place, but you need to push the top into the middle ring. Just gently push it in there, it should flex enough to get it in. If you want to extend it, I made a Video about that: https://youtu.be/JtzqknQWMgI

Technical Data: A single PopUp Pine Takes roughly 2 hours to print and 50 g of Filament. I used Protopastas Fleck and Forest Green and SUNLU Silk PLA+ Light Gold (the best Gold you can find)