My personal Design of a Stanley Tumbler As a keychain that can hold a ChapStick, a Glue Stick or other small items with a Lid that Easily Locks in with a Twist. My tumbler files Require supports, please make sure your supports are positively affecting the model. the lid can be tight at first due to design, wears over time due to pla toughness. and different materials and colors have different tolerances. No glue necessary. I use A Lobster Clap for the keychain spot these are what i have used from amazon https://a.co/d/8vqmPt5

This is Version 3 3MF file for the tumbler for easy multi color printing.

This is not a physical item please see my etsy for a physical version.

files are in a compressed zip folder and has to be unzipped (on windows right click and unzip)

The keychain can hold one of two different sizes of items, with one size holding a 22mm diameter and 80.55mm tall item and second size holding a 28mm diameter and 43.45mm tall item. Please message me if you want a custom size.

the version one Tumbler Outer Size 2.09” Inch Wide. (Handle to to opposite side) 1.46” Inch Deep. 3.94 Inch Tall.

Inner Size 0.858” Inches Bottom Diameter. 1.212” Inches Top Diameter. 3.346” Inches Top to Bottom Height. 1.968” Inches Top to Mid section Height before changing to smaller diameter for the bottom.

So it can hold up to one of these sizes at a time 0.858” Inch Diameter, 3.346” Inches Tall. Or 1.212” Inches Diameter, 1.968” Inches Tall. 3D printing settings

supports Are Required for each piece support under tumbler handle. outside of tumbler lid and tumblr lid line. make sure your supports are under 0,2mm away from the supported area.

if bed slinger i would recommend a brim. layer height and nozzle width to your liking of detail of the design.

ams or machine stop at layer to change for a silver color for the top of the tumbler.