On my quest to upgrade my K1 SE, my previous cable chain frame mount did not fit the K1C lid.

Since I decided to add a riser to my K1C, I could use a flat piece of polycarbonate and decided to use it for my K1 SE to trap more heat in. But in order to do that I needed to redesign the frame mount for the cable chain to line up with where the cut out is on the K1C lid.

I tested with the lid, power cord and PTFE filament tube to make sure it was placed right and the lid could sit all the way down.

If you do this as well, please note that the K1C has screws on each corner for magnets in the lid to attach to that helps keep it down when the chain goes knocking into it. The M3 holes for this are not milled into the K1 SE bodies. YMMV whether that matters or is an issue for you.

Note: Will not fit the K1C. The hole pattern for securing the cable chain frame mount are different, the K1C has 2 M3 holes. This model is to match the one found on the K1 SE. If for whatever reason you need one for the K1C and can't find one, let me know.