Here I have designed a two piece phone case design, I have made it myself, and it is designed to fit the iPhone 13, however it could possibly fit the iPhone 14 or 15.

GUIDELINES / EXTRA INFORMATION:

• The model labelled 'BASE PART' has 4 holes on each corner, these are 2mm in diameter, and are threaded to M2 x 0.4 as per the ISOmetric standard.
• The case labelled 'BASE PART' has 4 slots carved into the inside of the case, these are designed to store pieces of rubber for shock absorption, you can use any rubber you like, the specs for the sheets will be listed below, - Top strip, 1.1mm thickness, any rubber, CUT TO SHAPE. - Side strips, 0.8-0.85mm thickness, any rubber, CUT TO SHAPE. - Back sheet, 0.6-0.7mm thickness, any rubber, CUT TO SHAPE.
• Between the parts labelled 'TOP CLAMP' and 'BASE CLAMP' there needs to be a neoprene gasket of thickness 0.5 - 1.0mm, this needs to be cut to shape based on the part labelled 'TOP CLAMP', this is used to protect the phone from shocks, and to protect the front of the phone from getting damaged by the clamping forces of the top clamp, it also helps hold the phone into the case without slippage.

ATTENTION!!

• This phone case is UNTESTED, I am NOT liable for any phones broken incase of a drop!, This case has been tested in simulations and it should protect the phone!

Extra notes:

• Modes is subject to the CC-BY-NC-SA licence! Please read the terms before downloading!