I designed these latches to replace the stock latches (part 128D) of the plutonium case for the 1:8 scale BTTF DeLorean model. Accurate to the max and only available in the highest resolution possible to get the best results.

What's included: The set contains 3 latches. Two of them are the same so that you can put them in the same position like Eaglemoss does and there's a 3rd one that matches the angle of the latch seen in the movie. So choose whatever setup you like most.

Painting instructions

1. Prime with Tamiya grey primer
2. Paint with Tamiya aluminium or Vallejo steel

Installation instructions

1. Remove the OP screws that hold the stock latches, should you already have put them into place.
2. Place the new latches and put the OP screws back in place. Remember to not overtighten the screws, stop screwing as soon as you feel resistance.