Extra service "Flexi Hammerhead Shark - New Type, and Mini Set" released!! https://cults3d.com/en/3d-model/art/flexi-hammerhead-shark-new-type-and-mini-set-print-in-place https://flexseedsshop.etsy.com/jp/listing/1662189648/flexi-hammerhead-shark-new-type-and-mini If purchased, commercial use license and 3mf files are available.

This is flexi hammerhead shark. No support or assembly is required, just 3D print and play.

💰Commercial Use💰 This model is not available for commercial use under "CC BY-NC-ND 4.0" below. Therefore, I am selling the upgraded model with additional detailing and a license for commercial use. If you want to sell my model commercially, please check my Cults, Etsy, and MyMiniFactory. https://cults3d.com/en/design-collections/3dflexseeds/commercial-use-ver https://flexseedsshop.etsy.com https://www.myminifactory.com/users/3dflexseeds/collection/commercial-ver

On Patreon, you can purchase public commercial models at a special discount, and new releases are available for free present🎁 In addition, you can get monthly exclusive models and generous welcome pack!! https://www.patreon.com/FlexSeeds

⚠Warning⚠ Be careful in environments with young children and pets! This model contains small parts. If not properly stored in an environment with young children or pets, it may lead to accidents such as accidental ingestion or injury. If infants or pets are present, please take appropriate measures depending on the situation, such as refraining from 3D printing or storing in an appropriate place.

Do not apply strong force! Applying strong force to a 3D printed model or throwing it may damage the model and lead to accidents such as injuries. In addition, debris from damage to the model may be accidentally ingested by infants or pets. If the model is damaged, dispose of it immediately.

Store them in an appropriate place. After 3D printing, store the model in an appropriate place out of reach of young children and pets. Proper adherence to the precautions will ensure safe use of the model.

🖨Print Setting🧵 　Infill:15-20% 　Filament material: PLA

[Layer Height] 　Layer Height: 0.2mm 　Initial Layer Height: 0.2mm [Seam] 　Seam Position: Aligned [Walls] 　Wall Loops: 2 [Initial layder Speed] 　Initial layer: 30mm/s [Other layder Speed] 　Outer wall: 30mm/s 　Overhang Speed : 0, 0, 10, 10, 10mm/s [10%, 25%, 50%, 75%, 100%] 　Bridge: 30mm/s [Acceleration] 　Outer Wall: 2000mm/s^2 [Support] 　Enable Support: none [Raft] 　Raft Layers: 0 layers (none) [Bed Adhension] 　Brim type: No-brim [Prime Tower] 　Internal ribs: none 　Width: 15mm 　Brim Width: 0mm (none) 　Infill Gap: 100% 　Rib Wall: none