Introducing M3D Spinners - Ocean Volume One!

As the name implies I intend on having this be an ongoing collection that, depending on feedback, has the potential to have a lot of variations!

Whats in the pack:

(4) Base Spinners - including a keychain base!

(3) Spinner Tops - Octopus, Crab, Stingray with many more to follow!

(2) Connectors - Finger Rest and Accessory

A couple of quick tips:

The bases do better with smoother filaments vs course filaments. If you want to use a course filament you may need to add some lubricant to the bearing portion to ensure smoother spinning.

The Accessory connector allows you to connect more than one spinner either at the top or bottom for dual spinning action. I also have a Stanley straw cap accessory I am working on that the Accessory connector will allow you to use the Spinner like a pin wheel on Stanley straws!

Last thing, I am planning on releasing a request form on Discord for members to request specific toppers to be included in future releases so if you aren't on our Discord be sure to join! The invite is in your Member Benefits page.

Ok really last thing, I have to apologize that these were not out on Friday as I had intended. There were a few tolerances that I needed to test and make sure would work across a variety of materials. I really appreciate everyone's patience!

Many thanks!

Jonathan - M3D

PS, Birthday Celebration information will come out tomorrow now as I haven't quite finished the write up. Again, many thanks for the patience!