File link: https://makerworld.com/en/models/734009#profileId-665781

If you would like to sell my model prints, please subscribe to my commercial plan

"Without much further ado, I give you: The Derek Zoolander Center for Kids Who Can't Read Good."

One of my favorite movies, a film of peek comedy. This is a classic scene that needs no explanation when you can see it yourself.

You print the pages separate due to their complex geometry and then you glue them together, trust me it's why easier to do that then peeling off the supports.

The plaque was not readable so I made a name plate that says the quote from the movie: “Derek Zoolander Center for Kids Who Can't Read Good and Who Wanna Learn to Do Other Stuff Good Too”.

Recommended settings:

Support (manual 0.3mm top Z offset 0.05mm bottom Z offset Brim (outer only) (This is recommended only for the separate pages)

I used 0.05mm bottom support Z offset because I was using matte and basic filament together and they were not sticking too well. If you're using only basic filaments you might be okay with 0.2mm Z bottom offset, but you can do whatever you think suits your filament type.

I used low infill and translucent filament to create the effect of see through glass

Sunlu PLA translucent Sunlu PLA silver Bambu PLA matte desert tan Bambu PLA basic black Bambu PLA basic dark green

https://youtu.be/LQc8NDKcnpM