File link: https://makerworld.com/en/models/1204347-darksaber-keychain-retractable#profileId-1217897

Hello! I was inspired to make this model after printing the cool Lightsaber keychain model made by @JosayaJosh

Please read the assembly guide. There are things that will help you after printing.

Some filaments print different, especially those that are wet or poor quality. You may need to adjust the sizes of the blades if not using Bambu filament. These are tight tolerances and can be tricky. This could be the same for matte and other materials other than pla, so let me know how it goes if you use these materials

Please don't leave a poor rating just because you couldn't get the tolerances honed in. It really does hurt designers

Refer to Makerworld for assembly guide

If you would like to sell prints of this model, please subscribe to my commercial plan