This is a Bag Rider designed and made specifically for the Barrett MRAD. It has more surface area than Barrett's model, but is cheaper, weighs less and is a nice contour.

A few Notes:

• Print with the bottom of bag rider on bed
• Print in Nylon for the best/long term results
• Print with Tree Support, 20 Deg threshold (BambuLabs settings)
• Print was designed around the following hardware for flush mounting:
• M5-0.8 x 25mm Socket Cap Bolt
• M5-0.8 Nut
• Do not go beyond hand tight when tightening bolt
• This is for personal use only, not for resale or commercial use
• Use at your own risk
• For Commercial Use, please contact me

If you find this model/print helpful, please make any donation to Operation Underground Railroad

This work is licensed under CC BY-NC-SA 4.0