Shhroooms-LOL (Virtual Trip in AI)

Print Time About 4 hrs 6 min

P1P/ Bambu Basic PLA in CMYK Colours (Total of 4 colors used) THIS IS NOT SET UP TO CREATE WITHOUT AN AMS but i am sure it is possible Recommended with Bambu Basic PLA CYMK & Print Profile But I use Often use other filament (Sunlu PLA+ white, Bambu PLA Magenta, Sunlu PLA+ yellow and Sunlu PLA+ light blue)as well Aux fan is OFF (if using one)

Settings are taken from https://wiki.bambulab.com/en/knowledge-sharing/CMYK-color-lithophane-printing-instructions%20 Lithophane created with https://lithophanemaker.com/Color%20Lithophane.html?fbclid=IwAR0zbiYVOGT2kV0MY4LtLbNk5rrg_wOd_bEsA2kpnxebZCTbBNzPyFu8h7g.#processing

I have also attached the file for the frame that fits this print and the LED source can be found at https://us.store.bambulab.com/products/bambu-cmyk-backlight-board?_pos=2&_sid=92ad4ca60&_ss=r

0.20 Standard Print Profile First Layer .1mm Other layers .15mm Classic walls 2 wall loops 5 top shell 3 bottom shell INFILL: 100% rectilinear Speed: Slow Down For Overhangs is Turned off (UNCHECKED) Prime tower enabled Brim/Bed Adhesion: None Needed Flushing set for 1.00 (you will need to adjust this for your filaments and machine type but i often range between .60 and .75)