THE ONLY GOOD BUG IS A DEAD BUG!

Join the front line with this high quality Helldivers 2 Recoilless Rifle 3D print model!

This 3D print model comes separated into STLs for easy 3d printing- the rifle is separated into 29 parts with 18 plugs, and the missile is split into 5 parts, for easy printing and assembly!

The rifle is able to be reloaded - you will need an 8mm bolt, with a 16mm OD washer and a nyloc nut, for the back cone to swivel. This lets you put the missile in, and then when in place, stops it from falling out. I have also allowed room for 6 3x2mm magnets to be glued, which will act as a lock for the swivelling mechanism.

I've also allowed for the front grip to have an M8 x 140mm cap head screw installed internally, to stop it snapping when held- this is fully concealed. An example of the screw you will need is - https://www.accu.co.uk/metric-cap-head-screws/2917-SSC-M8-140-A2 You'll also need an M8 hex head nut, and an allen/hex key to screw it all in. To install this handle with the internal screw, fit the nut into the allocated hex space behind the FrontGripRail, before gluing the rail into place. Make sure the screw hole matches the hole in MainBodyThree! Then, slide the FrontGrip into place, and line up the hole with the matching hole in the FrontGripRail. The nut will be held in place by the print, and then simply tighten the screw until it's flush in the hole. Finally, glue the FrontGripCap in, and you're done! A note on this - make sure you don't get any glue in the nut when you're gluing the rail into place. This may seize the hole and not allow the screw to marry into place.

When assembling the rifle, make sure to do a dry fit before gluing! The side clamps need to be slotted in before the main body is assembled. The front barrels should also be rotated into place to ensure the inside fluted chamber lines up.

Please note - this is not an official replica, but I do always take care to be as accurate to in game models and references as I possibly can be!

You can also find more examples of my work or get in touch with me at - https://www.instagram.com/theforge_props/

Sale of my models does not include a commercial license to use my images, sell my models, prints of the models or finished props- you can get in touch via my email or on instagram if you want to discuss potential licensing terms.

EDIT 25/6/2024: New individual front/back side clamps as channel slot differs by 5mm. Each labelled for easier identification once printed