.png&w=3840&q=85)
.png&w=256&q=75)
.png&w=256&q=75)
Spinny Plant Pot - Twist Together Pot with Built in Drip Tray
2.6K downloads · 2 years ago · [Instructions](https://prinnit.com/ForgeCore/design/3683r122rHEAMl6xlLBoN3sgjz3?tab=instructions&hig
Instructions Hardware Filaments
Spinny Plant Pot - Beginner This Plant pot is not only aesthetically pleasing, its also fun and functional. It is made from two parts that spin together, and has a build in drip tray to prevent root rot.
These pots were designed in collaboration with Hendrick's Design, who makes nice looking plant pots.
This design was inspired by those spinning containers, but made functional as a plant pot. If there's interest, I can make more styles of this planter as well, with different exterior patterns, or taller so it spins more.
Spinny Plant Pot - Twist Together Pot with Built in Drip Tray
2.6K downloads · 2 years ago
Lucky Bamboo Mahjong
PlayBook'd - Go
Telephones Booth
Spinny Succulents - Pack III
Desktop Golf Gen 2
PlayBook'd - Playing Cards
Desktop Dumpster
PlayBook'd Cribbage
PlayBook'd Crosswords
Snack Attack - Gen 2
PlayBook'd Snakes and Ladders
.png&w=3840&q=75)
Date Night Daisy
PlayBook'd Settlers' Storage
Scoopy Stacks
Butterfly Fridge Magnets - Pack II
Playbook'd - Checkers
PlayBook'd - Shut the Box
PlayBook'd - Hook and Ring.3mf
Paint Can Drying Rack
I also print will all the settings you supplied on my bambu x1 carbons, but I always have stringing issue with the overhang at the top of the insert pot. is there something I can do without using support? this is a great planter and I have success with it but I have to do a lot of clean up on that under hang of the stringing.. i know this an older model but I love the concept and wondered if we could have more similar? Planters with built in hidden bottoms are the best.
Hi there! Thank you for the feedback. I'm glad you like the model! You could try adaptive layer height at the point where it starts stringing which will reduce the stringing.
i printed this one to specifications in the picture and slowed it down and its still really stringy in the middle. is that just how it is. I printed it rightside up first and noticed the lip was stringy.
Print with Adaptive layers right at that section and it will come out great! (This setting is enabled in the 3mf)