BLOB BUNNY

UPDATE 2025-04-16 fixed front legs being too tight

The Blob Bunny is back with some much needed updates. There's a version where you can print the ears and nose separately. The Bunny can also be printed with magnets so it can nibble on a carrot. The carrot even has better leaves. The body is printed at an angle for a stronger neck joint. I've also adjusted the proportions a bit and sized it down to make it even cuter.

Features

• flexi legs
• articulating head
• magnetic carrot
• prints without supports
• print in parts or multicolor

PERSONAL USE ONLY

Purchasing or downloading this file does not give you the right to sell physical prints of this design. Commercial license is available for this design by subscribing to patreon.com/bloblab

COPYRIGHT PROTECTED FILES

All Blob Lab designs are protected under copyright law. Your purchase does not give you the right to sell or distribute the digital files in any way.

FILAMENTS

If you'd like to purchase the same filaments used in this design, please check out the Blob Lab Amazon Storefront affiliate link amazon.com/shop/bloblab3d

PRINT INSTRUCTIONS

• .12mm layer height recommended for high quality
• 3 perimeters for joint strength
• print without supports
• pause at the 4mm mark to add a 3x10mm magnet to the head, pause at 11.4mm for the carrot
• eyes snap into head, use superglue if too loose, scale parts or adjust X-Y compensation if needed
• brim recommended for ear parts
• glue on ears and nose
• snap head on to body
• 3MF files are for color information only, print settings may need to be adjusted