#HalloWearable #HalloWearables

I've uploaded and update here: https://thangs.com/dmEngineering/Squid-Game-Mask-Sliding-STLs-32520 This version has the sliding action.

For the STP Assebly go here: https://thangs.com/dmEngineering/Squid-Game-Mask-28341

Here is the guard's mask from Squid Game. The mask is divided into pieces for better printability.

Here are the steps to make it.

1. print all the 3 parts
2. if you didn't print the parts black, spray paint them with black primer
3. Glue Top to Bottom using the groove to align the parts
4. Glue the forehead band into the inward slots of Top
5. If you printed the forehead band in PLA you can use a hot air gun to make the part more comfortable.
6. use masking tape and white paint to make triangle a square (a circle is much harder)
7. tie an elastic band to one of the outward slots of top.
8. test fit the mask and tie the other end of the band to the other slot to have a firm but comfortable fit.
9. Wear the mask with a red hoodie and enjoy your cool and affordable costume.

If you have doubt comment here.