ryobi guide wall mount.stl

for ryobi track guide 6.5inches wall mount (print 2), uses M4 nut and bolt, very tight fit on nut and bolt gently hammer the nuts in and the bolt will ensure a tight fit.

how to print: handle : print flat mount : print on its thinner side, use supports if u wish (recommended on the top portion (of the mount piece) that touches the bed where it curves, however supports ARE NOT needed and will print as is but will look slightly weird lol

how to use:

1. first twist bolt all the way til the bottom is flush with the back side,
2. then mount to wall
3. slide track saw into place and then twist the cap til it holds the track 4.profit