Case for Glamos Walker

I designed this for 3 main reasons :

1. The power button is easily accidentally activated while mapping (e.g. when the device is in your pocket ) with this case the button is recessed 
2. To add a loop to allow the Glamos Walker to be attached to a lanyard or belt-clip
3. To add some ruggedization to the the device and/or prevent damage if dropped etc.
Print in TPU with < 50% infill (this gives a more cushioning effect)
orient bottom side on the plate (the side with most surface area) The overhangs on the top surface should print OK without support with good settings - It also helps if the ambient temperature is very cold when printing :-P


Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

valintw

Achievements

Seedling

Case for Glamos Walker