Case Studs.stl

This is a simple coupler for 3DPRINTINGWORLD's Collapsing Sith lightsaber. It is simply the cap part with a thread on the top as well. Once put together you can have a double-bladed saber! This also works with the custom saber found on my page.

>Printing Settings:
>᠎
>Supports are not needed as the overhangs aren't bad. I didn't use supports and it is smooth (you can see in the image.)
>I didn't use adhesion, but a raft would be best if you chose to do so.

Double Bladed Collapsing Lightsaber Coupler

This is a simple coupler for 3DPRINTINGWORLD's Collapsing Sith lightsaber. It is simply the cap part with a thread on the top as well. Once put together the full lightsaber hit will be shorter than the Maul saber by 3DPRINTINGWORLD, but allow for longer, removable blades.

>Printing Settings:
> I used an ENDER 3 S1
>Supports are not needed as the overhangs won't affect functionality, however, should be used if you want perfection.
>I didn't use adhesion, but a raft would be best if you chose to do so.

This is a simple crystal cut in half that can be glued into the Darth Maul saber made by 3DPrintingWorld (Linked below) 

The crystal is made to be glued in so it can be seen at the bottom just like in The Clone Wars.

I've made it the perfect size to fit with the connector piece screwed in aswell so you don't have to worry about that. Just make sure when you glue it you centre it as best you can to make sure it fits snugly in the connector.

My Links: https://www.youtube.com/channel/UCxOaFVXwiVLFIJC9q1DpnLg

https://www.youtube.com/@UmarDDDPrints/featured

3DPrintingWorld:
https://thangs.com/designer/3dprintingworld/3d-model/Maul%27s%20Collapsing%20Lightsaber%20-619364
https://thangs.com/designer/3dprintingworld


Kyber Crystal for Darth Maul's Saber

A Nintendo Switch dock cover that looks like some chips! (I'm British)
Made this one in TinkerCAD and thought it would be a fun little project to make for myself and for everyone else here!

French Fries Switch Dock Cover

This is a custom lightsaber that I designed and made in TinkerCAD. It uses the base geometry of 3dprintingworld's collapsing sith lightsaber (Darth Vader's lightsaber) and so you should print the blades from his page.

Using TinkerCAD, I removed all of the details from the lightsaber and started adding my own. Some are custom-made, but some were used from the original model, only adjusted slightly.

Custom Lightsaber

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

umarmooraby

Achievements

Seedling

Voyager

Pinned models

French Fries Switch Dock Cover

Case Studs.stl

Double Bladed Collapsing Lightsaber Coupler

Kyber Crystal for Darth Maul's Saber

French Fries Switch Dock Cover

Custom Lightsaber