Just another boring calibration cube that is 20x20mm with X - Y - Z extruded.  Has Tripod's Garage on the bottom.  What?  Were you expecting something exciting?

Tripod Cube.stl

BIQU 7in HDMI Case Front and Back to be used with the BIQU Hurakan.  Use M4*6*6 Embedded Nuts (Brass Heat Set Inserts) for the back .  The front of the case is a little loose, once attached to the Hurakan it will press along the side and be secure.
**Print the front of the case, bezel side down
**Print the back flat side down.
No supports needed.  Might need to clear out the screw holes before securing it.  Use the screws provided with the BIQU 7in Display for the 4 corners.  You will need to purchase M4*6*6 heated inserts for the rear holes.

BIQU HDMI 7in Case Front and Back 

BTT HDMI7 Front V1.stl

This is a very simple way to fasten your xTool D1 to your wasteboard, some might call it a spoilboard.  You must remove the rubber stoppers under the stand-offs, otherwise they will not fit.

xTool D1 Leg Tie Down v1.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

tripodsgarage

Tripod Cube.stl

BIQU HDMI 7in Case Front and Back

xTool D1 Leg Tie Down v1.stl