Robert P
Awarded to:toytaco2003
25 Models downloaded
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
profile hero image
toytaco2003’s profile picture

toytaco2003

0 followers0 downloads

Achievements

First Make published badge
Novice Maker
First Make published
25 Models downloaded badge
Trailblazer
25 Models downloaded
All
Sort by:

Sunflower Lamp

Sunflower Lamp - Printed this as a Christmas gift for my grandmother, Sunflowers are her favorite and we lost our grandfather some years ago. I thought adding the 60mm lithophane disc to the center was a nice touch. Now she can have the two things she loves the most on her nightstand. If you decide to do a Litho like I did I recommend printing it in, at minimum, PETG. The Lithophane does touch the bulb and is a very tight fit to get in. The tolerances were a tad on the small side for some of the pedals and yellow parts of the iris and the bottom cap for the pot BUT that might have been an issue with my printer calibration. - 3d model

Monstera Coaster Set

Monstera Coaster Set - Print looks good, I had an issue with some of the initial layers on the stem (see last picture) where they are "floating". It does not affect the quality, just clean up with a debur tool and hit with some heat. If you magnets seem weak check how far they are inset into the stems. Mine were below flush, trimmed the ends with a knife (see second to last picture) and it is MUCH better, the leaves don't fall off by themselves now. Filament Used: Polymaker Jungle Green and Cream, Bambu Labs Jade White and Brown - 3d model
AboutBlog
Apps
Download ThangsThangs SyncBlender AddoniOSAndroid
Help
HelpFAQSupport
Legal
LegalTerms & ConditionsPrivacy PolicyContent Policy
Feedback