Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5557365.

I have a bunch of old shorts that are in near perfect condition except the waistband is so loose it's gained a few sizes. If their are strings allowing to tighten the waistband, run them through this to loosely "lock" them at you're desired tightness while still allowing for easy stretching. This may also work for working waistbands as a lazier tightener. Still works after machine washing & drying even with heat but you may want to check your filament and washer/dryer specifications.

This is designed to slip inside the waistband between the string holes and run the strings through the locking slits. _You may need to cut some stitching in the center of the waistband to slip it through._ The easiest method I've found to insert it is by: 
1. Slipping one string through the side slit
2. Folding the opposite flap outwards
3. Inserting the tightener through the first string hole
4. Pulling the tightener through the opposite string hole
5. Slipping the other string through the side slit
6. Slipping the strings through the second slits - two options:
  - Cross the strings and insert them through the opposite flap slit. _The flaps will "tie" each other and hold, but may also break easier if over-tightened._
  - Insert the strings through the same side flap. _Less likely to break, but may not maintain tightness as well._
7. Simply pull the strings to tighten and pull the waistband to loosen

Parametric Waistband Tightener

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5713170.

A flag grommet wall mount and cover to make your flag look like it's floating on the wall when printed with filament the same color as the flag. Works best by mounting with a nail, or alternatively use some sort of adhesive (_**NOTE**: using strong adhesives may rip the paint off drywall when removing_). Can also be used to simply cover up or fill the grommets. 

Adjust the dimensions to fit your flag's grommet size (**NOTE**: I had a flag with a dented grommet, so using the smallest diameter of the dented grommet allowed it to fit snugly.)

Hidden Flag Grommet Wall Mount

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5713343.

A simple, snug can lid that works with most cans. I mainly intended it to store leftover canned foods in the fridge without having to use another container.

Parametric Snug Can Lid

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5713362.

A simple and stable table leg extender. Specify the leg dimensions and desired extension height, then fit the table leg snugly in the inset. Increase or decrease the base width to adjust the stability.

Stable Table Leg Extender

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5713139.

An adjustable door latch addon to prevent doors from loudly shaking when closed. Should fit most loose doors, but I designed it parametric to adjust the dimensions for best fit. 

Screw it into the wall side of the door latch with the lip inside the hole and the angled end out to compress door latch.

Adjustable Doorlatch

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

timtimmahh

Achievements

Seedling

Parametric Waistband Tightener

Hidden Flag Grommet Wall Mount

Parametric Snug Can Lid

Stable Table Leg Extender

Adjustable Doorlatch