Awarded to:theozroth

25 Models downloaded

Oct 4, 2025 · 8:22 PM

theozroth

0 followers0 downloads

Achievements

Trailblazer

25 Models downloaded

Novice Maker

First Make published

Sort by:

PEN HOLDER GHOST / PEN ORGANIZER HALLOWEEN EDITION

PEN HOLDER GHOST / PEN ORGANIZER HALLOWEEN EDITION - Both prints: Prusa Smooth PEI sheet. Ironing enabled. Generic super glue to connect the eyes to the body. Room temperature 72F, no enclosure. Filament kept Prusa MK4 filament holder, no filament dryer (traveling for holidays).

Eyes: printed at 10% infill; 2 minute completion time. Inland PLA+ (Black) with "Generic PLA" settings in Prusa Slicer.

Ghost: 1h 35min completion time (details above). Monoprice PLA (White), approximately 17 years old but only recently opened. Temp: 215F nozzle for all layers, bed 60F for duration of print. I used the default supports in Prusa Slicer, but noted they did not go across the full arm. I regret not painting on additional supports (I considered doing so briefly) as a hole developed in the right armpit. I used a few tools to clean up the stray filament that hadn't bridged correctly for the arm, as well as the undersides of the arms where the supports had connected.

Functions as intended. - 3d model