Hello everyone! Finally I have a working version of the Funko Pop Stages. Right now I have two variants. One in Figurine and one in "box" mode.
Please send me request for other sizes.
These are the final ones... They can mount with VHB tape (RED STUFF From 3M) or Command Strips link is there from amazon. The Figurines use one and the boxes can use three or two.
I left screw holes in the wall cleats to allow for that option too. These are strudy. The Stages are designed to be slid in from either side OR you can simply snap them over the front. You can also remove them this way. Just make sure your tape or adhesive is setup. But these should snap on the front with a satisfying "click".
You can use the Figurine Wall Cleat for Boxes and Vise Versa. They are the same.
I hope you all with a huge collection start using these. But moreover LETS SELL THESE... I made these because I saw the obscene amount of current models being sold on TikTok Shop... A 6 pack for $12 that has a total plastic cost of less than $1. While these use more plastic, I would absolutely say a 6 pack of these should sell for $25 to $30... and these look more professional, are easy to align, are removable... shall i continue.
This patreon has been and is focused on you all making profits. Please take these and get paid.
ALL PRINT ON SIDE, NO SUPPORT, NO BRIMS NONE OF IT. I designed these carefully to print with no aids at all.
I have included a 5x5 pack on ONE plate in Bambu Studio. A plate of 5 Stages for Figurines and 5 Box Stages is about $15 in materials. After time and Labor - $35 and you're making 60% Margins.