I ripped the model from the game (and the idle animation pose) and beefed up the fingers and head fins (poorly). I also extended the feet and back tail so I could crop it in slicer to make it sit flat. But is is printable.

I have also included the raw game files if you would like to edit it yourself.

Risk of Rain 2 Newt

newtThick.obj

Ripped straight from the game using [Asset Studio](https://www.youtube.com/watch?v=zgglKNFbvfk).

It needs to be scaled up (it was modelled in inches, yuck) but it's surprisingly printing-friendly. Prints fine without supports although PrusaSlicer suggests using a brim due to low bed adhesion.

Risk of Rain 2 Newt Altar

NewtStatueMesh.obj

A 3D printable version of [Vertx's Rapid Access Tab](https://vertx.com/rapid-access-tab-kit)

---
PRINT SETTINGS
Supports: None

---
EXTRA HARDWARE REQUIRED
1x Zip Tie (2.5mm wide)

---
ASSEMBLY
1. Slip the head of a zip tie into the slot
2. Feed loose end of zip tie through existing pull tab, through the hole at the top of the rapid access pull tab, through the head of the zip tie, out the hole on the side of the rapid access pull tab
3. Tighten the zip tie as needed and trim flush to the rapid access pull tab

Rapid Access Zipper Pull Tab

Rapid Access Tab Zipper pull.step

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

sskki

Achievements

Seedling

Risk of Rain 2 Newt

Risk of Rain 2 Newt Altar

Rapid Access Zipper Pull Tab