Angle measure tool(Rough draft)

Hello. This is my first prototype of my angel measure tool. It is in early development so its not 100% perfected yet! The measurement may be a few degrees off however I'm working on it

You will need to drill a small hole down the round piece in the center of the model so i would recommend a 100% infill and a little bit of a scale up wouldn't hurt!

If you have any feedback feel free to reach out or comment

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

slc2k11

Achievements

Seedling

Angle measure tool(Rough draft)