CNC Power Brick Holder - LiteOn

This is a mount for the LiteOn 24V 5A power supply that came with my 3018 Pro CNC router.
(see photos)

Lack Leg Extension

This is a 6cm leg extension for an IKEA Lack table. I wanted to use a LACK as a frame to an enclosure for my Anycubic Mega Pro 3D printer. The legs on the Lack are about 6cm too short to clear the top of the printer. This simple block has a hole trough the middle to enable you to attach it to the end of hte lack leg using a 2.5 inch deck screw. (because that's what I had around the house)
The screw will be inset 1 cm into the bottom of the leg so that it does not stick out and interfere with the table's balance or scratch any surface it sits on. 

You can also find me on Thingiverse.
https://www.thingiverse.com/rodmacpherson


Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

rodmacpherson

Achievements

Seedling

CNC Power Brick Holder - LiteOn

Lack Leg Extension