CR2450 holder and dispenser for Multiboard using MultiConnect connectors. You will need two MultiConnect connectors, also. Standard Multiboard print settings are fine, although you may need mouse ears or a brim for the sharp front points. This is my first Onshape project that works as intended, so happy to hear any helpful advice! I am PurpleAvenger on Onshape. NOTE: THESE USE MULTICONNECT, NOT MULTIPOINT! I will be redesigning to be standard Multipoint. Multiconnect can be found here: https://www.printables.com/model/1074671-raised-multiconnect-generic-connector-for-multiboa - I used "Big Coin Slot, Foldable.stl"