A 3d printed model of Tengen Uzui Katana from demon slayer.
printing settings easy to print scaling: scale this down depending on your build volume (I printed mine at 60%) layer height: 0.2 wall line count: 2 infill: 10% support: no use a raft if you're struggling with bed adhesion Printing time: 2h35min
assembling Check the assembly video here 👇tiktok :https://vm.tiktok.com/ZMLbBsUdE/ Instagram: https://www.instagram.com/reel/CclQZqdpec9/?igshid=YmMyMTA2M2Y=
assembling is easy just install part 1 (the handle) with part 2 and 3 just snap the parts into place, then use super glue to glue part 4 (the blade) and glue it in it's position. the clearance on this model is 0,3mm so depending on your printer clearances you may need to sand part 3 a little bit.
NOTE : this model is licensed under_ theCreative Commons - Attribution - Non-Commercial - Share Alikelicense._ happy printing