Bosch SPS53E18EU dishwasher outer shell

The outer shell of a Bosch SPS53E18EU, including the door, based on manual measurements. I used it to design a small clip to keep the door ajar, also available amongst my designs.

Bosch SPS53E18EU outer shell

Dishwasher door stopper for Bosch SPS53E18EU

Our dishwasher’s (a Bosch SPS53E18EU) door is either fully closed or half-open and in the way: the door’s spring mechanism pulls it closed if it’s open less than 45°. We like to keep it slightly ajar to avoid smells to build up inside. We are using a small plastic plug to do this, but it’s annoying as it falls down when the door is opened and one has to replace it carefully when closing the door back.

This thing can be clipped on the device and hold the door just slightly ajar and can be clipped off when you want to close it. It falls down if the door is slammed close but it can withstand normal usage. Good precision is not required, but it needs to be robust, so I printed it with 0.2mm layer height and no infill.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

peter.gyongyosi

Achievements

Seedling

Bosch SPS53E18EU dishwasher outer shell

Dishwasher door stopper for Bosch SPS53E18EU