Low-Poly Masquerade Mask by Perihelion Prints

=====

For attachment to head, use elastic cord or ribbon. Hot glue should work. For fitting, place the mask on your face, lining it up with your nose. Measure how much ribbon you'll need to go around your head, then add a bit more and cut two equal halves. Glue one to each side of the mask, and use the leftover length to tie both pieces into a knot or bow behind or head. Or you can edit the file to come up with your own solution.

Sculpted in Blender. STL and .blend files included. Dimensions in millimetres.

Includes a "quad mesh" variant and a triangulated variant. The quad variant is ironically quite high-poly because it takes quite a bit of geometry to represent quads instead of triangles in this way. But both should be fully printable and they're otherwise identical.

=====

"WOMNE HALTER NECK DRESS" used in demo render (https://skfb.ly/pAFAv) by ritikeshkerkettaoraon is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

=====

0.20mm layer height recommended.

Organic supports recommended.

PLA/PETG recommended.

Filament Usage (estimated): 35g

Printing Time (estimated): 2h25m

^ Estimates based off slicing for Prusa MK3.9. Your mileage may vary.