Vax Onepwr Battery Charger Mount

The battery charger supplied with the Vax Onepwr cordless vacuum cleaner does not have any holes to mount it, just feet to stand it on the work top. This is quite annoying because you can't unplug the battery one handed.....

VERSIONS:

There are 3 versions; 

  -V0 is the original with one of the screw mounting holes slotted (after I struggling to get the one I printed level) 
  -V1 basically the same with a slight embellishment to match the charger profile. 
  -V2 The same as V1 with the screw mounting holes in the other face. If you print this version then don't forget the cable fits through the slot so some thinking about that aspect s needed.

PRINT PARAMETERS:

•	0.6 Nozzle (0.4 Nozzle should be fine, adjust layer height accordingly)
•	0.4 Layer Height
•	4 Walls and 15% Infill
•	Print on the slotted face with no supports.
•	Print the main part in PLA with the PAD (x2) ideally printed in TPU and glued, however, if TPU is not available then PLA should be okay.

All of my Designs are covered by a Creative Commons Non-Commercial License.



Vax Onepwr Battery Charger Mount

Vax Onepwr Battery Charge Mount V0.stl

Remix of eight_heads BX version https://www.thingiverse.com/thing:4682915/files. This was done primarily for the Ender 5 Pro but will fit any BIQU H2 installation.

This version gives 360 degrees of cooling. I've also remixed the mount so that its slotted for height adjustment and also off-set from the hot end so the heater cable can run up the front of the extruder. This also allows better airflow for the extruder cooling fan.

I've also included a spacer/gap adjuster (2mm) which can be placed under the fan duct to help support and set the gap and keep it parallel to the bed while making the final adjustments and tightening of screws. Carefully use terminal commends to raise the bed until Z0 position is reached with the spacer in position, then nip the screws on the mount, fit the fan and tighten. Finish by lowering the bed and removing the spacer.

----------------------------------------

PRINT PARAMETERS:
  -0.2 Layer Height
  -3 Wall and 100% Infill
  -Print in PETG as a minimum due to closeness to the heater block.

-------------------------------------------

All of my Designs are covered by a Creative Commons Non-Commercial License.

BIQU H2 Extruder Front Mount 5015 Fan Duct

Fan_Duct.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

novocane

Vax Onepwr Battery Charger Mount

BIQU H2 Extruder Front Mount 5015 Fan Duct