Interlocking Building Block Toy

Found some of these little interconnectable "building blocks" toys - comes as a tube of 72 six pronged interconnected doodads in the dollar section at a popular chain store that is fond of the color red.

I saw how simple they were and decided I'd just measure them up and print a few extras for my kiddo, since I knew they'd likely get lost immediately. 

My print time is about 10 minutes per "block", and I've been using Orca Slicer with precise walls and Arachne wall generator at .12mm Fine on an Ender 3 with a standard 0.4mm nozzle and Inland PLA+

Do note that they pair well with the blocks from the box, but if you pair the PLA blocks together with one another, they can be difficult to disconnect

building block v3.3mf

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

northstarVimes

Achievements

Seedling

Trailblazer

Interlocking Building Block Toy