Stand for the Teenage Engineering “OP” line of synths.

Works on a desk or in your lap, and is designed for use with:

• OP-1
• OP-1 Field
• OP-XY (retains access to the pitch bend controller)

The minimum angle is 20º and supports larger angles by rotating and repositioning the feet. Has enough clearance to keep a Decksaver on your synth. 3D-printed plastic tends to slide on hard surfaces so I added rubber feet to the bottom of the stand (not shown in pics) to prevent that from happening. (It'd be interesting to see this printed in TPU!)

I purposefully made the tolerances tight to prevent shift/wobble while playing the synth.

This 3MF is optimized for PLA and uses a .28mm layer height with a 1/128" clearance between the parts. This results in nicely fitting parts that make repositioning the feet easy while maintaining the same stability. I do not detect any shifting or wobble while playing.

I haven't yet run into a strength issue resulting from printing the feet vertically which could result in a weak structure susceptible to torque/shear forces. If you experience that issue, try increasing the number of walls first, then printing the feet horizontally or at 45º instead of vertically.

The 3MF file is for OrcaSlicer and includes supports.