This model is restricted by licensing terms.
View license.
0 Likes5 DownloadsOctober 17, 2021
This model is restricted by licensing terms.
View license.
Does you Roomba get stuck on low ridges? With this bumper you lower the standard bumper to about 1cm.
To install, just unscrew the bottom of the bumper, place this print and fasten with the same screws.
No supports needed. 0.3mm layer height.
Categories:
0 Likes5 DownloadsOctober 17, 2021
This model is restricted by licensing terms.
View license.
0 Likes5 DownloadsOctober 17, 2021
This model is restricted by licensing terms.
View license.