Lost Factory Cube - A generalist *diagnostic* cube

This cube tests for a lot of basic calibration and hardware issues on an FDM printer, all at once.

You need to print this cube:- 

at 0.2mm layer height
on a 0.4mm nozzle (or smaller) with 0.4-0.46 line width
The screw and rod parts snap off to test in the screw holes and normal holes. There are ghosting, overhang, cooling, ovality tests among other things. 

This work is licensed under a
Creative Commons (4.0 International License)
Attribution-NonCommercial, you may not redistribute this commercially, please link to this source. You can however show it in your videos or whatever, commercial or otherwise. 

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

lostintech

Achievements

Seedling

Explorer

Debutant

Lost Factory Cube - A generalist diagnostic cube