Cable Teeth Holder

Holds 11 cables, from thick USB 3.1 to tiny earbud cables. I have gone through several iterations of the design so that it is easy to drop a cable in, and it is easy to remove a cable. Taking a cable out does not accidentally knock it's neighbors off.

Designed to be zip-tied to semi-standardized wire shelving (could also be Command Strip'd to wall or other flat surface).

requires 2x M3 x 12 or longer screw and two M3 hex nuts to assemble.

Highly optimized for FDM printing: no overhangs with angle-to-vertical greater than 45 degrees, and very short bridges. This is a very forgiving design to print. Can be printed with tall layer heights and as fast as your printer can go.

With a 0.4mm nozzle, 3.2mm layer height, 210% extrusion width, 80mm/s movement speed, and 15mm^3/s volumetric speed, I was able to print this design in 1.6 hours on a completely stock Prusa MK3S.

I have included .3mf files with my exact settings, so if you have a Prusa MK3 you can open it in Prusa Slicer, close your eyes and hit print.


cable_teeth_both_parts.3mf

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

lint_kid

Achievements

Seedling

Cable Teeth Holder