L
Awarded to:linisgre
First Make published
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
profile hero image
L

linisgre

0 followers0 downloads

Achievements

First Make published badge
Novice Maker
First Make published
All
Sort by:

Spill Proof Coffee Carrier

Spill Proof Coffee Carrier - Tilted when carrying. Initial print was fused together on bottom and top, not separable, using Bambu Lab X1 Carbon, Bambu Lab PLA Matte White, door/lid closed. Printing again (GST3D PLA+ White, open door/lid) gave me an articulated print (see picture). Magnets had to be forced in and caused slight bulking of the thin wall. Generally result looks good, but is not working too well. While carrying, there is a noticeable tilt (picture shows the carrier being held still in the air). This is due to the hair pin not being above the center. In the "official" pictures, the hair tie seems to be closer to a point above the center of the tray as it is in the printed version (as also noticeable in some of the other images uploaded here), where the hair tie is significantly offset and way closer to the border than the center. This means any cup can't be too full as it would swap over. But then one could just carry the mug by hand ... Not sure where this discrepancy comes from, this can't be a scaling/shrinking/whatever issue. Is the hinge supposed to lean further out? (not possible on my print as there is not enough clearance, the picture shows the max already) - 3d model