Awarded to:ldu_labs

First Model uploaded

Jul 6, 2025 · 9:38 AM

ldu_labs

12 followers220 downloads

Achievements

Novice Maker

First Make published

Voyager

50 Models downloaded

Seedling

First Model uploaded

Debutant

100 All-time downloads

Sort by:

Multiboard Angled Spray Can Holder

Multiboard Angled Spray Can Holder 3d model

Desk Edge Cable Holder (Print upright, no supports)

Desk Edge Cable Holder (Print upright, no supports) - Orca Slicer
- Crosshatch infill
- Ironing on all top surfaces
- Precise wall and z-height

Printed as expected, no issues with spinning the collars. Printed in ~45 minutes with ~22g of filament. - 3d model

Full Size Anatomically

Full Size Anatomically - Excellent model, the missing magnet cup on the Right Parietal Bone does not make any notable difference in the strength. Printed on a Bambu P1P, 0.4mm nozzle using 0.16mm Optimal settings in Orca slicer. 10% gyroid infill with tree supports used ~500g of MH Build series PLA in Bone White. Total print time was ~ 22h with 21mm^3 max vol. flowrate.

During assembly I found that the large magnet pockets could fit two 6x2mm magnets stacked, and the small could fit a 3x1.5mm magnet. If I did it again I'd order 6x4mm magnets for the larger pockets. All were sourced from Amazon, no issues with holding power. - 3d model