A head band set with 2 options for halloween related objects to be featured on top of your head.

A unique system where an electric tealight of diameter 37mm (available on Amazon), can be mounted into a connector which slides and locks into 2 positions on the headband. This allows the positioning to be directly on top of the head or slightly off at an angle.

The pumpkin and house model have been created to provide a snug tolerance with the connector so it should stay in place but should also be removable.

Maybe you could create your own objects to attach to the top of the connector?

Print instructions: Some parts have been split in half for an easier print - these will need to be glued together on assembly

Layer height - for detail, you may wish to print at a low layer height, especially for the pumpkin model.

You probably want to keep walls and infill to a minimum to lower the weight of the objects on top - especially the house and roof.

Most of these parts will require support but I'll leave that decision to you.

HalloweenWearable